中英文打本知识小结
……检查发现/报告故障……1. 航后：检查发现左后航行灯不亮。
After Flight(AF )：Find L AFT position light is not on.
2. 检查发现右前轮磨损超标。
Check R tire of the nose landing gear is worn out of limits.
3.检查发现2号ATC故障。
Check ATC system No.2 ATC fails.
4. 检查发现左外刹车组件磨损超标。
Check L outboard wear indicator pin of MLG brake assy is out of limits.
航后检查发现：(AF Check)
AF Check ：Check L outboard wear indicator pin of MLG brake assy is out of limits.
Accomplish Task Card：TZ-AF-03，check L outboard wear indicator pin of MLG brake assy is out of limits.
过站检查发现：(TR check)
TR check : Check L outboard wear indicator pin of MLG brake assy is out of limits.
Accomplish Task：TZ-TR-00，Check L outboard wear indicator pin of MLG brake assy is out of limits.
5. 检查发现左主起落架一液压管漏油超标。
Check the L MLG hydraulic tube leakage is out of limits.
6. 检查发现13B座位小桌板不能收起，无法保持在收上位。
Check the NO.13B passenger tray table could not be stowed and hold on the stow position.
Accomplish Task：：xx-xx-xx，Check the NO.13B passenger tray table could not be stowed and hold on the stow position..（完成xx-xx-xx工卡发现…）
AF Check ：Check the NO.13B passenger tray table could not be stowed and hold on the stow position（航后检查发现…）
TR check : Check the NO.13B passenger tray table could not be stowed and hold on the stow position（过站检查发现…）
7．机组报告空中右发燃油滤旁通灯亮。
The flight crew reported right engine Fuel FILTER BYPASS Light came on in flight.
8. 航后APU自检有49-41012故障信息.
AF Check: maintenance message 49-41012 is displayed after APU BITE.
9. 前洗手间“有人、无人”标牌松动。
The “None/Occupied” placard in forward lavatory is loosening.
参考/按..更换（件）……，检查 / 测试正常
1. 过站：根据AMM32-45-21更换右前轮，并根据AMM 12-15-51/301检查轮胎气压正确。
TR Check：Refer to AMM32-45-21 to replace the R nose wheel，and refer to AMM 12-15-51/301 to check the tire pressure，ensure the tire pressure is normal.
2. 根据AMMXX-XX-XX更换2号ATC收发机，并根据AMMXX-XX-XX对系統完成测试，结果正常。
Refer to AMMxx-xx-xx to replace the No.2 ATC transceiver，and Refer to AMMxx-xx-xx to do a system function test，the result is normal.
3. 航后根据AMM49-41-11更换APU起动机，启动测试APU工作正常。
AF: Refer to AMM49-41-11 to replace the APU starter，start APU and do an operation test，the result is normal.
4. 过站根据AMM25-22-00折下第三排ABC座椅，座椅随机放在前货舱。
TR：Refer to AMM25-22-00 to remove the passenger seats 3A/3B/3C，and leave in the FWD cargo compartment.
5. 根据工卡XXXX，更换时控件电瓶，根据AMMXX-XX-XX测试电瓶电压为XX伏，符合手冊要求。
Refer to task card xxxx to replace the time control battery，AMMxx-xx-xx to test the voltage is XX volt，and satisfy to AMM requiements..
检查发现…故障，按…保留，…号/类别，同意放行
1. 过站检查发现前服务话筒失效，按MEL23-20放行飞机。
TR Check: Find the FWD attendant handset failed，refer to MEL23-20 to dispatch.
Accomplish Task card：TZ-TR-00，Find the FWD attendant handset failed，refer to MEL23-20 to dispatch..
2. 航后检查发现右发PRSOV失效，因航材无料，根据MEL36-5完成M项工作，将右发PRSOV锁关位放行，在右发引气电门处贴不工作标牌，并办理保留DD3000000。
AF Check: Find the R engine PRSOV failed. Accomplish maintenance (M) items per MEL36-5 and lock the PRSOV in close position prior dispatch due to lacking of spare parts. Paste the“R ENGINE BLEED AIR SYSTEM INOP”tag next to the R engine bleed air switch，The deferred defect form NO. is DDXXXXXXX.
按…，更换…件，测试正常，撤消 / 关闭…保留
1. 航后依据AMM23-20-00，更换前服务话筒，并完成功能测试结果正常，撤消DD/FCXXXXX。
AF：Refer to AMM23-20-00 to replace the FWD attendant handset， Accomplish a function test and the result is normal，rescind deferred item DD/FCXXXXX.
2. 航后根据AMM36-11-04, 更换右发PRSOV，并根据AMM36-11-04完成功能测试，结果正常，撤除DDXXXXX
AF: Replaced the right engine PRSOV refer to AMM36-11-04, and accomplish the function test per AMM36-11-04, the result was normal, close the DDXXXXX.
遭 遇 冰雹/鸟 击
1. 过站检查发现雷达罩和右发进气道口有鸟击痕迹，根据AMM05-51-18完成冰雹/鸟击后的检查，并根据AMM27-81-00/27-51-00完成前/后缘襟翼的操作测试，结果正常。
TR Check/ Do Task Card：TZ-TR-00，find a Bird/Hail Strike track on the radome and the R engine inlet cowl，refer to AMM05-51-18 to accomplish the Bird/Hail Strike Conditional Inspection，and refer to AMM27-81-00/27-51-00 to do a operation test of leading edge device and trailing edge flap，the result is normal.
为判断…故障/因为航材缺件，对串…件，测试…
1. 为判断B-2652自动刹车故障，根据AMMXX-XX-XX将P2-2面板与B-2650对串，并完成系统功能测试，结果正常。
For troubleshooting of auto brake system of B-2652，refer to AMMxx-xx-xx to interchange the P2-2 with B-2650，and do a function test，the result is normal.
2. 由于航材缺件，为判断右发引气故障，根据AMMXX-XX-XX对串左右发引气调节器，试车检查结果如下:左发:N1=XX 引气压力为XX PSI; N1=XX 引气压力为XX PSI; 右发:N1=XX 引气压力为XX PSI; N1=XX 引气压力为XX PSI;引气压力正常。
For troubleshooting of R engine bleed air system abnormal，refer to AMMxx-xx-xx to interchange bleed air regulator with L engine due to lacking of spare parts，do the engine running-up test，the test parameters are following：L Engine：N1=xx%，Bleed air pressure=xx PSI；N1=xx%，Bleed air pressure=xx PSI；R Engine：N1=xx%，Bleed air pressure=xx PSI；N1=xx%，Bleed air pressure=xx PSI；bleed air pressure is normal.
更换……件，试车检查……
1. 根据AMMXX-XX-XX更换右发引气压力调节器，试车数据如下: N1=XX 引气压力为XX PSI; N1=XX 引气压力为XX PSI，结果正常。Replaced the R engine bleed air regulator according to AMMXX-XX-XX，and did the engine operation test, the data was: N1=XX, bleed air pressure= XX PSI; N1=XX bleed air pressure =XX PSI; the result was ok.
Refer to AMMxx-xx-xx to repalce the R engine bleed air pressure regulator，the relative data parameters are following: N1=xx%，Bleed air pressure=xx PSI；N1=xx%，Bleed air pressure=xx PSI；the bleed air pressure is normal. 挺好的资料，收藏了 收藏起来也好，谢谢了。 好资料，每次写本的时候可以拿出来看看 写的不错，以后有用 我今晚把它都记下来 mark一下，常来学习，充实自己写本子的能力。
现在写本子比干活难啊！ 挺好的收藏了 还是比较实用的啊~ 很好，填本的时候方便了 好东西，明天正好要考试这个呢 收藏了，谢谢楼主 挺好的东西！ 很专业下来 看看 挺好的资料，收藏了看看 这个内容以前看过，但是要谢谢楼主再贴出来。 很有用，谢谢楼主
页:
[1]