分 享 即 成 长 。大 家 好,欢 迎 关 注 阮 工 频 道 。
发动机上有很多管路,上面都有一层胶皮
▼
在我们日常检查的时候
偶尔会发现防火胶皮损伤 ▼
那么碰到这样的损伤到底能不能放行呢, 手册的标准又在哪里?
下面就来找一找
轻点 ☟ 「AMM 70章」
不在!
轻点 ☟ 「AMM 20章」
也不在!
还轻点 ☟ 「AMM 73章」
没有!
再轻点 ☟ 「AMM 79章」
还没有!
啊,再轻点就要出来了 ☟ 「AMM 72章」
怎么样,完全没有想到会是在72章吧?
下面以前面的防火胶皮为例,看看手册的标准:
4) Cuts in the fire sleeve in areas A and B: NOTE: Area A is defined as follows: L = 2.5 x hose OD at the two ends of the hose.Area B is defined as the length between the two areas A. a) Up to 3 cuts that do not cross per hose section are permitted if the length is not more than 0.20 inch (5.1 mm). b) If the cuts are more than the limit, replace the hose
5) Tears in the fire sleeve material in area A: a) Not permitted, replace the hose. b)
6) Tears in the fire sleeve material in area B: a) One per hose section is permitted if the depth is not more than 0.010 inch (0.25 mm) and the total area is not more than 0.40 square inch (258 square mm). b) Replace the hose.
参考5),需要更换该管子。
需要注意的是,此处的发动机管路检查标准是一个通用标准,只有在手册其他地方未给出标准时,才使用。这一点,这部分检查程序开始部分也有说明:
NOTE:The limits in this procedure are general and do not replace the limits on components given in other locations in this manual. If you will examine the fuel manifold, refer to this task: Fuel Manifold - Inspection/Check, TASK 73-11-05-700-801-F00.
- END -
|